電動卷簾門的原理以及它的電機安裝是您在使用卷簾門之前建議來了解的，不然就很容易造成使用問題的出現，下面來看看是怎么回事吧。

The principle of electric rolling shutter door and its motor installation are recommended to understand before using the rolling shutter door, otherwise it is easy to cause use problems. Let's see what's going on.

電動卷簾門根據電磁感應來實現電能轉換傳遞的電磁裝置，它的作用是用來控制卷簾門的自動升降，從而達到我們防盜的作用，非常方便，磁感應不光能夠用來當做卷簾門，還能利用熱能、水能等推動發電機轉子來發電。

Electric roller shutter door is an electromagnetic device that realizes the conversion and transmission of electric energy according to electromagnetic induction. Its function is to control the automatic lifting of roller shutter door, so as to achieve our anti-theft function. It is very convenient. Magnetic induction can not only be used as roller shutter door, but also use heat energy, water energy, etc. to drive the generator rotor to generate electricity.

電動卷簾門電機不光有一種種類，按照結構和工作原理可以劃分為直流電動機、異步電動機和同步電動機。而同步電機可以劃分為永磁同步電動機、磁阻同步電動機和磁滯同步電動機;異步電機可劃分為感應電動機和交流換向器電動機。異步電動機的轉子轉速總是略低于旋轉磁場的同步轉速，同步電動機的轉子轉速與負載大小無關而始終保持為同步轉速。

There is not only one kind of electric roller shutter motor, which can be divided into DC motor, asynchronous motor and synchronous motor according to its structure and working principle. Synchronous motor can be divided into permanent magnet synchronous motor, reluctance synchronous motor and hysteresis synchronous motor; Asynchronous motor can be divided into induction motor and AC commutator motor. The rotor speed of the asynchronous motor is always slightly lower than the synchronous speed of the rotating magnetic field, and the rotor speed of the synchronous motor is always kept at the synchronous speed regardless of the load.

安裝電動卷簾門電機一定要由人員來進行安裝于維護，須要良好地接地，不然會出現漏電現象。卷簾門電機運行時一定不可以在門下站立或者同行，不可以有阻礙物，定期對電機做檢查，保證聲音沒有異常，運行順滑，不然很容易造成人身和影響卷簾門壽命。

The installation and maintenance of the electric roller shutter motor must be carried out by professionals, and it must be well grounded, otherwise there will be leakage. When the roller shutter door motor is running, it must not stand under the door or walk together, and there must be no obstacles. Check the motor regularly to ensure that there is no abnormal sound and smooth operation, otherwise it is easy to cause personal safety and affect the service life of the roller shutter door.

卷簾門電機的工作環境一定要在-25攝氏度到55攝氏度之間，濕度大約為90%(25攝氏度)。在安裝卷簾門電機之前應該松開限位機構的鎖緊螺釘，然后拉動環形鏈讓簾們離開地面一米左右，然后來試用，按上下左右和停看看是否靈敏可靠，如果正常就能將門簾上升或者下降了。

The working environment of the roller shutter motor must be between -25 ℃ and 55 ℃, and the humidity is about 90% (25 ℃). Before installing the roller shutter motor, you should loosen the locking screw of the limit mechanism, then pull the ring chain to keep the curtains about one meter away from the ground, and then try it. Press up, down, left, right and stop to see if it is sensitive and reliable. If it is normal, you can raise or lower the curtain.

濟南電動卷簾門安裝維修人員建議您要調整碰微動開關滾輪：聽到“滴達”聲后：擰緊鎖緊螺釘;然后進行反復調試，將限位達到佳的位置后，將鎖緊螺釘用手指用力旋緊卷門機應水平安裝，門簾卷軸應該水平、同心，沒有停滯卡住的現象。調節鏈條的下垂應該在轉軸沒有掛門簾錢調整，大約0.6-1厘米左右，卷簾門的供電外接電源線應該盡量少露出來。

Jinan electric roller shutter door installation and maintenance personnel suggest that you should adjust the roller that touches the microswitch: after hearing the sound of "dripping", tighten the locking screw; Then conduct repeated debugging. After the limit reaches a good position, tighten the locking screw with fingers. The door roller should be installed horizontally, and the door curtain roller should be horizontal and concentric, without stagnation and jamming. The drooping of the chain should be adjusted without hanging the curtain on the rotating shaft, about 0.6-1 cm. The external power line of the rolling shutter door should be exposed as little as possible.

電動卷簾門的點擊開啟和關閉只需要操作開關按鈕，卷簾門到位后會自動停止才符合標準。如果需要在中間停留可以隨時按下停止按鈕就可以了。還有個好處就是卷簾門電機在停電的情況下可以手動操作，殺死用收拉動環形鏈條就能讓卷簾慢慢上升。

To open and close the electric roller shutter door, you only need to operate the switch button, and the roller shutter door will automatically stop when it is in place. If you need to stay in the middle, you can press the stop button at any time. Another advantage is that the roller shutter door motor can be operated manually in case of power failure. Killing and pulling the annular chain can make the roller shutter rise slowly.

電動卷簾門的原理以及它的電機安裝就是這樣了，為了人員的使用以及卷簾門的使用，真的要來認真了解了，更多資訊就來關注網站//domachine.com.cn。

This is the principle of electric roller shutter door and its motor installation. For the safety of personnel and the safety of roller shutter door, we really need to carefully understand it. For more information, we will pay attention to the website //domachine.com.cn 。