經濟不斷的發展，生活水平不斷的提高，家家戶戶都有了小汽車，對于擁有車的家庭必定有車庫，那么車庫的電動卷簾門的安裝過程中有哪些需要注意的呢?濟南車庫門安裝維修小編整理了一些關于車庫的電動卷簾門的相關信息。

With the continuous development of economy and the continuous improvement of living standards, every household has a car. For the family with a car, there must be a garage. What should be paid attention to during the installation of the electric roller shutter door in the garage? Jinan garage door installation and maintenance team sorted out some information about the electric roller shutter door of the garage.

1、先在需要安裝的門框框口位置畫出線，表明尺寸大小，然后找工作人員設計出合適的電動卷簾門(注意:框內高度比門扇的高度要高一點)。

1. Draw a line at the opening of the door frame to be installed to indicate the size, and then find the staff to design a suitable electric roller shutter door (Note: the height inside the frame is higher than the height of the door leaf).

2、把電動卷簾門的門框固定，這里要先拆掉門框下部的固定板(注意:洞口兩側地面要預留凹槽，經校正合格后，固定木楔，門框鐵腳與預埋鐵板件焊牢。用水泥砂漿或強度不低于10MPa細石混凝土嵌塞牢固即可)。

2. To fix the door frame of the electric rolling shutter door, the fixing plate at the lower part of the door frame shall be removed first (Note: the groove shall be reserved on the ground at both sides of the opening. After the correction is qualified, the wooden wedge shall be fixed, and the iron foot of the door frame shall be welded with the embedded iron plate. It can be firmly plugged with cement mortar or fine aggregate concrete with strength not less than 10MPa).

3、安裝電動卷簾門扇主體門扇。一定要保證電動卷簾門與墻體結成整體，封閉性要做好，再粉刷洞口及墻體。粉刷完畢后，門縫應均勻平整，開啟電動卷簾門應該自由輕便，不得有過緊、過松和反彈現象。

3. Install the main door leaf of the electric roller shutter door leaf. Make sure that the electric roller shutter door and the wall form a whole, and the sealing shall be done well, and then paint the opening and the wall. After painting, the door seam shall be even and flat. The electric roller shutter door shall be free and light to open, and shall not be too tight, too loose or rebound.

車庫卷簾門尺寸大小，主要依據門面房的高度和寬度來定。車庫卷簾門幾乎是不會受到任何限制的，其大制作高度可達到9米-14米，大制作寬度4米-12米。

The size of the rolling shutter door of the garage is mainly determined according to the height and width of the front room. The rolling shutter door of the garage is almost free from any restrictions. Its large-scale production height can reach 9 meters to 14 meters, and the large-scale production width is 4 meters to 12 meters.

常見的車庫卷簾門尺寸:

Common garage roller shutter door size:

卷軸一般選用直徑80mm的圓管，根據門的大小端座尺寸有所不同，以使用情況確定是否需要罩殼。一般小型的單車庫門(寬度3m以內，高度2.5m以內)選用55型號或77型號的簾片，大型雙車庫門則選用77型號簾片。

Generally, the spool is a round pipe with a diameter of 80mm. The size of the end seat varies according to the size of the door, and whether the cover is required is determined according to the use situation. Generally, Model 55 or model 77 curtain shall be selected for small single garage doors (width less than 3m and height less than 2.5m), and model 77 curtain shall be selected for large double garage doors.

車庫卷簾門是以多關節活動的門片串聯在一起，在固定的滑道內，以門上方卷軸為轉動上下的用于車庫的門。車庫卷簾門按照開關類型分為手動車庫卷簾門和自動車庫卷簾門。

The rolling shutter door of the garage is a door used for the garage, which is connected in series by multi joint movable door pieces and rotates up and down with the roller shaft above the door in a fixed slide. The rolling shutter door of the garage is divided into manual rolling shutter door and automatic rolling shutter door according to the switch type.

車庫卷簾門能夠大程度上的滿足各種尺寸需求，具有很好的防護性能，不占用車庫門內部空間，適用于商業門面、車庫、、醫院、廠礦企業等公共場所或住宅的車庫。

The rolling shutter door of the garage can meet the needs of various sizes to a large extent, has good protection performance, and does not occupy the internal space of the garage door. It is suitable for the commercial facade, garage, shopping mall, hospital, factory and mining enterprises and other public places or residential garages.

安裝車庫的電動卷簾門，一定要辦證電動卷簾與墻體結合整體的效果。封閉性要做好，再粉刷洞口以及墻體，粉刷完畢了過后，門縫還要均勻平整，這樣在開啟車庫卷簾門過程中應該自由輕便，不會出現過緊，過松或者是反彈的現象。更多相關事項就來我們網站//domachine.com.cn咨詢！

When installing the electric roller shutter door of the garage, it is necessary to verify the integrated effect of the electric roller shutter and the wall. The sealing shall be well done, and then the openings and walls shall be painted. After the painting is finished, the door seams shall be even and flat. In this way, the rolling shutter door of the garage shall be free and light in the process of opening, and there shall be no over tightening, over loosening or rebound. For more information, please visit our website //domachine.com.cn consulting service