卷簾門怎樣注重后期的保養?

來源：//domachine.com.cn/  發布時間：2023-04-09 15:27:58

選擇一個好的卷簾門是非常重要的，同樣重要的是在以后的使用中注意維護卷簾門。平時維護保養好卷簾門是非常重要的，以免因使用不當造成卷簾門損壞，直接影響產品的使用壽命。使用卷簾門時，我們可以注意以下事項：

Choosing a good roller shutter door is very important, and equally important is to pay attention to maintaining the roller shutter door in future use. It is very important to maintain the rolling shutter door well in daily life to avoid damage caused by improper use, which directly affects the service life of the product. When using roller shutter doors, we can pay attention to the following:

1.請勿用尖銳的硬物撞擊門板，以免損壞門板，影響整體美觀和使用壽命。

1. Do not use sharp hard objects to impact the door panel, as it may damage the overall appearance and service life.

2.請勿電機通電時檢修和清潔，以免造成危險。

2. Do not inspect and clean the motor when it is powered on to avoid danger.

3.門體嚴禁接觸酸堿溶液或腐蝕性氣體，以免腐蝕門簾涂層。

3. The door body is strictly prohibited from coming into contact with acidic or alkaline solutions or corrosive gases to prevent corrosion of the door curtain coating.

4.使用卷簾門時，盡量保持控制器和電壓穩定。嚴禁安裝在非常潮濕的環境中，不要隨意打開遙控器。如果發現電線纏繞在門上應該及時處理。注意通道是否堵塞，防止門下降，如有異常反應，立即停止電機運行。

4. When using roller shutter doors, try to keep the controller and voltage stable as much as possible. It is strictly prohibited to install in a very humid environment and do not open the remote control casually. If wires are found tangled around the door, they should be dealt with promptly. Pay attention to whether the channel is blocked to prevent the door from descending. If there is any abnormal reaction, stop the motor immediately.

5.定期檢查電動卷門上下行程開關，給行程控制器添加潤滑油，保持正常良好運行。此外，操作員手動控制卷簾門，檢查檢查運行狀態，并檢查上下行程開關的位置，以便電動卷簾門在打開或關閉時處于適當的位置。在檢查過程中，應嚴格防止電動卷門碰頂、碰底或倒轉。緊急情況下，應立即停止旋轉并切斷電源。

5. Regularly check the up and down travel switches of the electric rolling door, add lubricating oil to the travel controller, and maintain normal and good operation. In addition, the operator manually controls the roller shutter door to check its operation status and check the position of the up and down travel switches, so that the electric roller shutter door is in the appropriate position when opened or closed. During the inspection process, it is necessary to strictly prevent the electric rolling door from hitting the top, bottom, or reversing. In emergency situations, the rotation should be stopped immediately and the power should be cut off.