The electric rolling shutter door has good anti-theft function. At the same time, the electric rolling shutter door also saves us the trouble of manually opening and closing the rolling shutter door, so the electric rolling shutter door is widely used, so what are the three problems that need to be paid attention to in the maintenance of the electric rolling shutter door? Next, roll up the door for you to popularize it.

1、要保持軌道運行暢通，及時清理電動卷簾門的軌道，保持清潔，卷簾門電機和傳動鏈條要經常加注潤滑劑，檢查控制箱內器件和開關控制盒，緊固接線端口，緊固螺絲等，清潔控制箱內、表面和按鈕上的灰塵污物，按鈕卡住而不能。

1. It is necessary to keep the track running smoothly, clean the track of the electric rolling shutter door in time, and keep it clean. The rolling shutter door motor and drive chain should be filled with lubricant frequently. Check the devices and switch control box in the control box, fasten the wiring port, fasten the screw, etc., and clean the dust and dirt in the control box, on the surface and on the button, so that the button is stuck and cannot be replaced.
                      

2、在電動卷簾門的使用過程中，要盡量保持控制器和電壓的穩定，禁止安裝在潮濕的環境，另外不要隨意打開遙控器，如若發現門體上有電線纏繞、打結等應及時處理。注意通道的是否堵塞，阻礙門體下降，如若發生異響應停止電機運作。

2. In the process of using the electric rolling shutter door, it is necessary to keep the controller and voltage stable as far as possible. It is forbidden to install it in a humid environment. In addition, it is not allowed to open the remote control at will. If it is found that there are wires winding and knots on the door, it should be handled in time. Pay attention to whether the channel is blocked to prevent the door from falling. If abnormal response occurs, stop the motor operation.

3、要經常性的檢查電動卷簾門上下行程的開關，對行程控制器加上潤滑油，保持正常良好的運行，另外，操作人員手動控卷簾門，檢查器運行情況，校對上下行程開關位置，使電動卷簾門開啟或關閉時處于適當位置，且檢查過程中嚴電動卷簾門沖頂或沖底或者反轉，如若出現緊急情況應停止轉動，切斷電源。

3. In addition, the operator manually controls the roller shutter door, checks the operation of the device, and checks the position of the up and down travel switch, so that the electric roller shutter door is in a proper position when it is opened or closed, and the top or bottom or reverse of the electric roller shutter door is strictly controlled during the inspection, In case of emergency, stop turning and cut off the power supply.