電動卷簾門如何保養，四大措施供您參考

來源：//domachine.com.cn/  發布時間：2020-07-27 13:44:39

 電動卷簾門如何保養，四大措施供您參考：
How to maintain the electric rolling shutter door? Four measures are for your reference:
1、在電動卷簾門的使用過程中，要盡量保持控制裝置和電壓的穩定，禁止安裝在非常潮濕的環境，另外不要隨意打開遙控裝置，如若發現門體上有電線纏繞、打結等應及時處理。注意通道的是否堵塞，阻礙門體下降，如若發生異響應立即停止電機運作。
1. During the use of the electric rolling shutter door, the stability of the control device and voltage shall be maintained as far as possible. It is forbidden to install it in a very humid environment. In addition, do not open the remote control device at will. If there are wires winding and knotting on the door body, it shall be handled in time. Pay attention to whether the channel is blocked to prevent the door body from falling. In case of abnormal response, stop the motor immediately.

2、要經常性的檢查電動卷簾門上下行程的開關，對行程控制裝置加上潤滑油，保持正常良好的運行，另外，操作人員手動控卷簾門，檢查器運行情況，校對上下行程開關位置，使電動卷簾門開啟或關閉時處于適當位置，且檢查過程中嚴防電動卷簾門沖頂或沖底或者反轉，如若出現緊急情況應立即停止轉動，切斷電源。
2. Regularly check the up and down travel switch of the electric rolling shutter door, add lubricating oil to the travel control device to maintain normal and good operation. In addition, the operator manually controls the rolling shutter door, checks the operation of the device, and proofreads the up and down travel switch position to make the electric rolling shutter door in an appropriate position when it is opened or closed, In addition, during the inspection, the electric rolling shutter door shall be strictly prevented from punching the top or bottom or reversing. In case of emergency, the rotation shall be stopped immediately and the power supply shall be cut off.
3、操作員經常性的要檢查好電動卷簾門的手動開關和手動升降裝飾，以防止在緊急的情況下電動卷簾門會失靈，或者造成不必要的事故。
3. The operator shall regularly check the manual switch and manual lifting decoration of the electric rolling shutter door to prevent the electric rolling shutter door from failure or causing unnecessary accidents in an emergency.
4、要保持軌道運行通暢，及時清理電動卷簾門的軌道，保持內部清潔，卷簾門電機和傳動鏈條要經常加注潤滑劑，檢查控制箱內器件和開關控制盒，緊固接線端口，緊固螺絲等，清潔控制箱內、表面和按鈕上的灰塵污物，防止按鈕卡住而不能彈回去。
4. Keep the track running smoothly, clean the track of the electric rolling shutter door in time and keep the interior clean. The motor and drive chain of the rolling shutter door shall be frequently filled with lubricant, check the components in the control box and the switch control box, fasten the wiring port, fasten the screws, etc., clean the dust and dirt in the control box, surface and button, and prevent the button from sticking and not bouncing back.