電動卷簾門壞了如何修理，濟南卷簾門維修公司告訴你

How to repair the broken electric rolling shutter door? Jinan rolling shutter door maintenance company will tell you

一、在電動卷簾門的使用過程中，要盡量保持控制器和電壓的穩定，禁止安裝在非常潮濕的環境，另外不要隨意打開遙控器，如若發現門體上有電線纏繞、打結等應及時處理。注意通道的是否堵塞，阻礙門體下降，如若發生異響應立即停止電機運作。

1、 During the use of the electric rolling shutter door, the stability of the controller and voltage shall be maintained as much as possible. It is forbidden to install it in a very humid environment. In addition, do not open the remote controller at will. If there are wires winding and knotting on the door body, it shall be handled in time. Pay attention to whether the channel is blocked to prevent the door body from falling. In case of abnormal response, stop the motor immediately.

二、要經常性的檢查電動卷簾門上下行程的開關，對行程控制器加上潤滑油，保持正常良好的運行，另外，操作人員手動控卷簾門，檢查器運行情況，校對上下行程開關位置，使電動卷簾門開啟或關閉時處于適當位置，且檢查過程中嚴防電動卷簾門沖頂或沖底或者反轉，如若出現緊急情況應立即停止轉動，切斷電源。

2、 Regularly check the up and down travel switch of the electric rolling shutter door, add lubricating oil to the travel controller to maintain normal and good operation. In addition, the operator manually controls the rolling shutter door, checks the operation of the device, and proofreads the up and down travel switch position to make the electric rolling shutter door in an appropriate position when opening or closing, In addition, during the inspection, the electric rolling shutter door shall be strictly prevented from punching the top or bottom or reversing. In case of emergency, the rotation shall be stopped immediately and the power supply shall be cut off.

三、操作員是經常性的要檢查好電動卷簾門的手動開關和手動升降裝飾，以防止在緊急的情況下電動卷簾門會失靈，或者造成不必要的事故。

3、 The operator should check the manual switch and manual lifting decoration of the electric rolling shutter door regularly to prevent the electric rolling shutter door from failure or unnecessary safety accidents in case of emergency.

四、要保持軌道運行暢通，及時清理電動卷簾門的軌道，保持內部清潔，卷簾門電機和傳動鏈條要經常加注潤滑劑，檢查控制箱內器件和開關控制盒，緊固接線端口，緊固螺絲等，清潔控制箱內、表面和按鈕上的灰塵污物，防止按鈕卡住而不能反彈。

4、 Keep the track running smoothly, clean the track of the electric rolling shutter door in time and keep the interior clean. The motor and drive chain of the rolling shutter door shall be frequently filled with lubricant, check the components and switch control box in the control box, fasten the wiring port, fasten the screws, etc., and clean the dust and dirt in the control box, surface and button to prevent the button from being stuck and not rebounding.

以上就是電動卷簾門壞了修理的具體辦法，你學會了嗎？其他有關電動卷簾門的分享歡迎訪問濟南電動卷簾門安裝維修：//domachine.com.cn/

The above is the specific method to repair the broken electric rolling shutter door. Have you learned it? Welcome to Jinan electric rolling shutter door installation and maintenance: //domachine.com.cn/